Tips and Hints Page

This is a page dedicated to all the tips, hints, and good ideas that people send me. They can range from a good way to put MonoKote on to a new way to attach a tail wheel. Anything you like!

So lets hear them! Send me all your great ideas. All write-ups can be submitted either in an e-mail or given to me on a disk, in a Word document form or something similar. A scrap of paper with something scribbled on it will work if I can read it. Pictures or sketches would be nice.

1. Disposing of Xacto Blades		17. Keep CA Glue Tips Clean
2. Epoxy Mixing Surface		18. Simple Wing Dihedral
3. Transferring Layouts, Drawings To Wood		19. Dihedral jack
4. Covering Gripper		20. Wing Sheeting
5. Finger Drills		21. Cracked Landing Gear.
6. Aluminum Hinge Tool		22. Long Push Rods
7. Cure for slipping TX		23. Table Top Protection
8. CA-Accelerator Dispenser		24. A Tight Fit for Cowlings
9. Balsa Wood Dust Collector		25. Basics of Electricity
10. Wheel Mounting		26. 12 Volt Power Supply
11. Battery Soldering Jig.		27. A simple shop clamp.
12. Soldering Gun Tip		28. Sheeting a wing with balsa.
13. Tee Nuts & Epoxy		29. Your name on Tx.
14. Cowling Screws		30. Electronic gear door sequencer.
15. Hinge Drill Fixture		31. Screw Tops for Paint Cans
16. A Simple Onboard Glow Driver		32. Battery - State of Charge