Tips and Hints Page

This is a page dedicated to all the tips, hints, and good ideas that people send me. They can range from a good way to put MonoKote on to a new way to attach a tail wheel. Anything you like!

So lets hear them! Send me all your great ideas. All write-ups can be submitted either in an e-mail or given to me on a disk, in a Word document form or something similar. A scrap of paper with something scribbled on it will work if I can read it. Pictures or sketches would be nice.

12 Volt Power Supply
A Simple Onboard Glow Driver
A simple shop clamp.
A Tight Fit for Cowlings
Aircraft Alignment
Aluminum Hinge Tool
Balance That Big Bird
Balsa Wood Dust Collector
Basics of Electricity
Battery - State of Charge
Battery Soldering Jig.

CA-Accelerator Dispenser

Center of Gravity

Covering Gripper
Cowling Screws
Cracked Landing Gear.
Cure for slipping TX
Dihedral jack
Disposing of Xacto Blades
Electronic gear door sequencer.
Engine-prop selection chart
Epoxy Mixing Surface
Finger Drills
Hinge Drill Fixture
Keep CA Glue Tips Clean
Long Push Rods
Screw Tops for Paint Cans
Seal those GAPS
Sheeting a wing with balsa.
Simple Brake System
Simple Wing Dihedral
Soldering Gun Tip
Table Top Protection
Tail Dragger Transitioning
Tee Nuts & Epoxy
Transferring Layouts, Drawings To Wood
Wheel Mounting
Wing Sheeting
Your name on Tx.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

HOME

Hit Counter    lop